Specifications

Electrical Specifications

The electric fryer requires 208 or 240 volt, three phase, 50/60 Hertz service. The power cord will be already attached to the fryer. Check the data plate mounted just above the lid, on the left side of the back shroud, to determine the correct power supply.

A separate disconnect switch with proper capacity fuses or breakers must be installed at a convenient location between the fryer and the power source. It should be an insulated copper conductor rated for 600 volts and 90° C. For runs longer than 50 feet (15.24 m), use the next larger wire size.

International Electrical Specifications

Units being used outside the United States may not be shipped with the power cord attached to the unit because of the different wiring codes. The fryers are available from the factory wired for 208, 240, 380 and 415 volts, 3 phase, 50 Hertz service. A terminal block is mounted inside the fryer for the cable wiring. A decal

on the inside of the right side panel will help in the wiring of the unit.

Height:	61” (155 cm)
Width:	24” (61 cm)
Depth:	41¾” ( 107 cm)
Floor Space:	Approximately 7 sq. ft. (0.65 sq. m.)
Vat Capacity:	8 head of chicken - 21 lbs (9.5 kg) 100 lbs oil (45 Kg)
Electrical:	208 VAC, 3 Phase, 50/60 Hz, 17 KW, 47.2 Amps 240 VAC, 3 Phase, 50/60 Hz, 17 KW, 40.9 Amps 200 VAC, 3 Phase, (Delta), 50/60 Hz, 17 KW, 49.1 Amps 240 VAC, 3 Phase, (Delta), 50 Hz, 17 KW, 40.9 Amps 380 VAC, 3 Phase, 50 Hz, 17 KW, 25.8 Amps 400 VAC, 3 Phase, 50 Hz, 17 KW, 25.0 Amps (CE) 415 VAC, 3 Phase, 50 Hz, 17 KW, 23.7 Amps
Heating:	Two 8,500 watt electric immersion elements
Shipping Weight:	Approximately 593 lbs. (269 kg.)

Data Plate Location

A data plate, located on the right side panel, gives the information of the type of fryer, serial number, warranty date, and other information pertaining to fryer.

In addition, the serial number is stamped on the outside of the counter top.