Troubleshooting

To isolate a malfunction, proceed as follows:

  • Clearly define the problem (or symptom) and when it occurs.

  • Locate the problem in the Troubleshooting table.

  • Review all possible causes. Then, one-at-a-time, work through the list of corrections until the problem is solved.

Problem Cause Solution
Product not holding temperature

 

 

 

 

   

Control temperature set too low

Increase air temperature

Door gasket damaged or worn

Replace bad door gaskets

Bad air heater

Check heaters and replace if bad See Tech Mode items 10 and 16

Blower not working Check blower and replace if bad See Tech Mode item 18
Air probe faulty, open (“E-6A”), or shorted (“E-6B”) Check probe resistance and replace, if necessary
Cabinet steaming product soggy Humidity setpoint too high Decrease humidity setpoint
Water heater probe faulty, open (“E-12A”), or closed (“E-12B”) Check probe resistance and replace, if necessary

Bad humidity sensor (“E-17”)

Replace humidity sensor

Vent stuck closed (“E-80”)

  • Bad vent motor - replace

  • Check alignment and condition of mechanical vent parts

  • Vent acorn nuts too tight, loosen, if necessary

Product dry

 

Humidity set too low

Increase humidity setpoint

No water in pan

Check water shut-off valve

Bad float switch Replace float switch

Bad water heater high limit

Replace high limit

Bad water heater Check heater and replace if bad; see Tech Mode item 18

Vent stuck open ("E-80")

  • Bad vent motor - replace

  • Check alignment and condition of mechanical vent parts

Unit not reaching set temperature

 

 

Doors left open

Keep doors closed except to load and serve product

Door gasket damaged or worn

Replace bad door gaskets

Thermometer not indicating true temperature Check cabinet temperature with another thermometer; have thermometer replaced if necessary
Blower not working Check Blower and replace if bad
Blower not working Check Blower and replace if bad; see Tech Mode item 18

Bad air heater

Check heaters and replace if bad; see Tech Mode item 18

Unit not heating

 

 

 

 

Bad high limit

Check high limit; replace if bad

Bad air heater

Check heaters and replace if bad; see Tech Mode item 18

Faulty wiring

Check for loose connections or broken wires

Unit not heating

Bad control board

Check set point reading; if unit for heat below setpoint and not calling for heat, control board defective. Replace control board

Blower not working

Check blower and replace if bad; see Tech Mode item 18

Water does not drain

Drain clogged

Remove drain obstruction