Replacing the JIB (Jug in Box)

When the JIB is empty, or when the message CHECK JIB appears in the display, replace the empty JIB with a new JIB.

Note: Some stores may use a BIB (Bag-in-Box) rather than a JIB. This is not a problem as the JIB tube on the fryer adjusts to fit both common JIB sizes as well as common BIB sizes. To replace the JIB follow these instructions:

  1. Open the door in front of the JIB. Pull the empty JIB out from under the fryer.

  2. Remove the JIB tube.

  3. Discard the empty JIB.

  4. Open the new JIB and completely remove and discard the paper or foil seal.

    5. Note: Keep foil or paper seals from falling into the JIB, or blockage or damage to the JIB pump may result.

  5. Insert the JIB tube into the new JIB until it reaches the bottom, then secure the cap down over the spout.

  6. Slide the new JIB back onto the JIB shelf then close the door.