Operating the ODS 460 with Evolution Elite Model Fryer

To avoid severe burns and equipment damage:

  • Use PPE.

  • Ensure filter pain is empty prior to removing from unit.

To avoid personal injury:

  • Use PPE

  • Do not overfill the oil disposal shuttle.

The ODS holds approximately half the volume of oil contained in the vat. To prevent splashing and spillage, drain no more than half of the oil in to the ODS at one time.

Burn Risk

To avoid burns, use PPE when connecting to or disconnecting from oil disposal unit.

To avoid personal injury, ensure cover is in place before moving shuttle.

Draining Oil from an Evolution Elite Model Fryer

  1. Ensure the shuttle's front sensor contactor is adjusted accordingly.

  2. Remove the filter pan assembly from under the fryer.

  3. Release the cover latch and hinge cover back on oil disposal shuttle. Make sure crumb catcher is in place as shown.

  4. When making multiple disposal trips, ensure the shuttle is completely empty to prevent splashing.

    If it is not empty, refer to Disposing Oil into Disposal Container.

  5. Perform Disposing Oil from an Evolution Elite Model Fryer.

Disposing Oil from an Evolution Elite Model Fryer

  1. Using the fryer controls, press and hold the Filter button (on either side) until *FILTER MENU*, along with “1.EXPRESS FILTER” displays.

  2. Press and release the right arrow button twice until “3.DISPOSE” displays.

  3. Press the confirm button and “DISPOSE?” along with “YES NO” displays.

  4. Press the confirm button and “OPEN DRAIN” displays.

  5. Pull-out the drain knob to open drain and “DRAINING” displays. Oil now drains from the vat into the oil disposal shuttle (ODS).

    Note: If oil disposal shuttle is not properly in place, “IS DISPOSAL UNIT IN PLACE?” displays. Adjust the bracket on the front of the shuttle as needed by loosening the 4 nuts securing the bracket and moving the bracket up or down. Once properly adjusted, “DRAINING” displays.

  6. “VAT EMTY”, along with “YES NO” display. Verify that vat is empty, and press the confirm button.

  7. “CLN VAT COMPLETE”, along with “YES NO” display. Once vat is clean, press the confirm button and close drain.

  8. “MANUAL FILL POT”, followed by “VAT FULL”, along with “YES NO” display. Fill the vat to the lower indicator line on the rear of the vat and then press the confirm button. Controls return to normal operation.

  9. Continue at Disposing of Oil into Disposal Container.

  10. Continue by filling the vat with fresh oil.