Optional Polish Cycle

The 3. POLISH option extends the usable life of the oil by removing debris through an extended polishing (filtration) process.

To manually start a polish, do the following:

  1. Press 3. POLISH. A confirm prompt displays. If the operator selects:

    • NO x, the display returns to the previous menu.

    • YES, the drain opens automatically and the oil begins draining. Downward pointing arrows display indicating the vat is draining.

    A 5 minute timer displays and starts. The oil cycles repeatedly through the drain pan filtration system until the timer expires, ultra cleaning the oil, also referred to as a polish.

    When the polish cycle completes, the display indicates that the oil is returning to the vat. The control panel chirps and a timer starts. Once the timer counts down, FILLED? displays.

    If the unit does not detect the oil returning to the vat or if the vat sensor detects the oil is below the full line the message IS POT FILLED? displays. Check the oil level to confirm the vat is full.

  2. If the oil is:

    • Level with the hot fill line on the back of the vat, press YES.

    • Not level with the hot fill line on the back of the vat, press NO x and the filter pump motor runs for an additional 30 seconds.