(missing or bad snippet)

Troubleshooting

Problem

Cause

Correction

Power switch ON but fryer completely inoperative.Open circuit

- Check circuit breaker

- Check plug

- Call for service

Fryer and control are on but oil will not heat

- High limit trip

- Drain valve open

- Reset high limit

- Close drain valve

Oil foams and / or boils over

- Water in oil

- Wrong or bad oil

- Improper filtering

- Improper rinsing after cleaning

- Drain oil and clean

- Use recommended oil

- Perform daily filtration

- Clean, rinse, thoroughly dry vat

Oil will now drain from vatDrain valve clogged with crumbsOpen valve and clear clog with drain brush
Filter switch ON but motor does not runMotor thermal protector trippedReset thermal switch

Burn Risk

To avoid burns, turn POWER switch to OFF before resetting pump motor.

Filter Pump Motor Manual Reset

The filter pump motor is equipped with a manual reset button, located on the rear front of the motor, in case the motor overheats. If motor won’t run, wait about 5 minutes before attempting to reset this protective device to allow motor to cool. Remove the access panel on the left side panel of the unit to reset the button. It takes some effort to reset, and a screwdriver can be used to help reset the button.

(missing or bad snippet)