Troubleshooting

Problem

Cause

Correction
Power switch ON but fryer completely inoperative. Open circuit

- Check circuit breaker

- Check plug

- Call for service
Fryer and control are on but oil will not heat

- E-10 error: High limit trip

- E-15 error: Drain valve open

- Reset high limit

- Close drain valve
Oil foams and / or boils over

- Water in oil

- Wrong or bad oil

- Improper filtering

- Improper rinsing after cleaning

- Drain oil and clean

- Use recommended oil

- Perform daily filtration

- Clean, rinse, thoroughly dry vat
Oil will now drain from vat Drain valve clogged with crumbs Open valve and clear clog with drain brush
Filter switch ON but motor does not run Motor thermal protector tripped Reset thermal switch

Burn Risk

To avoid burns, turn POWER switch to OFF before resetting pump motor.

Filter Pump Motor Manual Reset

The filter pump motor is equipped with a manual reset button, located on the rear front of the motor, in case the motor overheats. If motor won’t run, wait about 5 minutes before attempting to reset this protective device to allow motor to cool. Remove the access panel on the left side panel of the unit to reset the button. It takes some effort to reset, and a screwdriver can be used to help reset the button.