Reversing the Lid Gasket

Reversing the lid gasket helps to prevent early failure of lid gasket and the loss of pressure during a cook cycle.

1. Back the 4 lid liner screws (2 on each side) out about 1/2 inch (12.7 mm).

   

2. Using a thin blade screwdriver pry out the gasket at the corners, and then pull gasket from lid.

   NOTE: Check the gasket for any nicks or tears. If the gasket is damaged, it needs to be replaced.

3. Clean the gasket and gasket seat with hot water and cleaning detergent. Rinse with clean hot water.

   

4. Install the gasket with the “good” side out and tighten the 4 screws.

   NOTE: Install the four corners of the lid gasket. Smooth the gasket into place, working from the corners towards the middle of each side.