Cleaning the Safety Relief Valve

To avoid severe burns, do not tamper with safety relief valve while operating fryer.

To avoid serious personal injury, do not tamper with safety relief valve. Tampering with this valve will void agency approvals and appliance warranty.

This valve is factory preset to open at 14½ psi. (999 mbar).

  1. Remove deadweight cap and deadweight.

  2. Use a wrench to loosen the safety relief valve from the pipe elbow, turn counterclockwise to remove.

  3. Clean the inside of the pipe elbow with hot water.

    NOTE: Turn the safety relief valve towards the rear of the fryer when reinstalling the relief valve.

  4. Immerse the safety relief valve in a soapy water solution for 24 hours. Use a 1 to 1 dilution rate. The valve cannot be disassembled. It is factory preset to open at 14-1/2 pounds of pressure (999 mbar). If it does not open or close, it must be replaced.