Controls and Indicators

Item No.DescriptionFunction
1

Product Selection Buttons

Select the number of heads, or product, to be cooked by pressing the button below the menued item; oil will then heat to drop temperature of that item

Pressing the same button again begins the Cook Cycle; the display changes from “DROP” to counting down the cook time in minutes and seconds

At the end of the Cook Cycle, the alarm sounds and the display reads “DONE”; press the cycle button that is flashing, to stop the alarm ; the fryer then resets to the Cool Mode

NOTICE - A Cook Cycle can be aborted at any time by pressing and holding the product button.

2

Time/Temperature Display

A four digit LED type display which shows the remaining cook time during Cook Cycles and also the oil temperature on demand from the operator

3

Heat Indicator

Illuminates whenever the control calls for heat; when oil temperature has been reached, the heat light goes off

4

HI Temperature Indicator

The display reads “HI” if the oil temperature is 40° F above the setpoint

5

Drop Indicator

The display reads “DROP” when the oil has reached the setpoint temperature (will read “DROP” 2° before setpoint and 4° above setpoint )

6

Done Indicator

The display reads “DONE” at the end of the Cook Cycle

7

Temperature Button

Press this button to read the temperature of the oil during a Cook Cycle

8

SCAN Button

Pressing this button toggles through the items being programmed

9

FUNCTION Button

Used in the programming of the controls

10

EXIT FILL Button

After filtering the fryer, if in the filter lockout mode, the display reads “FILL”, and the EXIT FILL button must be pressed.

11

EXIT COOL Button

After cooking, or filtering the oil, the temperature automatically goes into the Cool Mode, which keeps oil at a lower temperature; this temperature extends the oil life and minimizes the time to heat the oil for the next Cook Cycle; EXIT COOL button must be pressed to heat up to setpoint temperature.

Burn Risk

Although the display will read "cool" during the standby mode, the oil is hot and will cause burns.