Using the SimpleHold Control

  1. Turn the power switch to the ON position and the actual temperature displays.

  2. To check the setpoint temperature, press and hold the SET button.

    NOTICE -

    Be sure to push the water pan in as far as it will go so that it does not block air from the thermometer and thermostat capillary tubes. This will ensure proper operation of these components.

  3. Remove water pan and put about 1 inch (25.4 mm) of hot water in pan. Return pan to cabinet.

  4. Allow unit to heat 25 to 30 minutes to reach setpoint temperature, and the heat indicator flashes, before loading product into cabinet.

Programming

To change the setpoint temperature, press and hold the SET button and then use the Up and Down arrows to set the desired setpoint temperature.

If the controls are locked the setpoint cannot be changed until the controls are unlocked. See Special Programming.