Intended Use

To avoid property damage or injury, read the Operation Manual before installing, operating or servicing this equipment. Retain this manual in a convenient location for future reference.

To avoid electrical shock or property damage, disconnect power before installing or servicing equipment. A qualified technician must perform the service procedures.

This appliance is not intended for use by persons (including children) with reduced physical, sensory, or mental capabilities, or lack of experience and knowledge, unless they have been given supervision or instruction concerning use of the appliance by a person responsible for their safety.

Children should be supervised to ensure that they do not play with, clean or perform maintenance on the appliance.

To avoid personal injury, keep floor surrounding equipment clean and dry. International appliance includes a permanently installed water circuit. Water pressure must be from Min: 20 - Max: 400 PSI (0.14Mpa - 2.76Mpa).

The unit is not intended for continuous mass production such as in a factory. During use, the airborne A-weighted emission sound pressure is below 70 db(A). This appliance is intended for commercial use in kitchens of restaurants, bakeries, hospitals, etc.

Always use strain relief. Install the provided power cord with the ground wire dimensioned to fail last. If the supplied power cord or an existing one becomes damaged, do not use it; rather, replace it with a known good power cord. The power cord must be replaced by the manufacturer, its service agent or similarly qualified persons in order to avoid a hazard. The unit requires a grounded receptacle with a separate electrical line protected by a fuse or circuit breaker of the proper rating.

It is recommended that a 30 mA rated protective device such as a residual current circuit breaker (RCCB), or ground fault circuit interrupter (GFCI), be used on the circuit. The supply power cords shall be oil-resistant, sheathed flexible cable, no lighter than ordinary polychloroprene or other equivalent synthetic elastomer-sheathed cord.

If the removal of the plug is foreseen, it is clearly indicated that the removal of the plug has to be such that an operator can check from any of the points to which he has access that the plug remains removed.

Recommended maintenance must be performed to ensure safe and continuous operation of unit. See Henny Penny operation instructions.

Unit should not be operated using an external timer or remote control system.