Cleaning

To avoid electrical shock or property damage, move the power switch to OFF and disconnect power.

Only perform this procedure when the unit is cool or severe burns may result.

NOTICE -

To avoid equipment damage, do not clean stainless steel with abrasive tools, abrasive cleaners or corrosive chemicals.

NOTICE -

To avoid component damage, do not use pressurized water or a steam cleaner to clean unit.

1. Turn the water thermostat to OFF.

2. Turn the radiant heat to OFF.

3. Turn the water control switch to OFF.

4. Remove the doors.

5. Remove all the pans.

   

6. Remove the drain standpipe.

7. Remove the insert from the water pan and clean with soap and water at sink.

8. If you have a two tier unit (CW-216), remove wire pan support from top section and clean with soap and water at sink.

9. Clean all surfaces with a soft cloth, soap, and water.

10. Clean around electrical controls with a damp cloth.

11. Install the drain standpipe and insert.

12. Turn off the lights.

13. Turn off the power switch.

14. Leave the doors open until ready to use again.