Changing Product Settings

This is part of Level 1 Programming.

  1. Press and hold the Temperature and Information buttons until LEVEL - 1 displays, followed by ENTER CODE.

  2. Enter code 1, 2, 3, 4 (first 4 product buttons). “PRODUCT” and “SELECTN” show in the displays.

  3. Press right the Confirm button and ‘SELECT PRODUCT’ and “-P 1-” (ex: NUGGETS) show in the displays.

    Change Product Names

  4. Use the Left and Right arrow buttons to scroll through the 40 products, or press the desired product button.

  5. Press right Confirm button and the product (ex: NUGGETS) displays on the left and “MODIFY”, and “YES NO” displays on the right. Press the the Confirm button to change this product, or press the Cancel button to choose another product.

  6. If the Confirm button was pressed, press and release a product button and the flashing letter changes to the first letter under the product button that was pressed. For example, if product button 1 is pressed, the flashing letter changes to an “A”.

    Press the same button again and the flashing letter changes to a “B”. Press it again and the flashing letter changes to a “C”. Once the desired letter displays, press the right arrow button to continue to the next letter and repeat the procedure.

    Press the down arrow button and hold the right Cancel button to exit Program Mode, or press button to continue on to “1. COOK TIME”.

    To Change Times and Temperatures

  7. Press the down arrow button until “COOK TIME” displays, and then use the product buttons to change the time in minutes and seconds, to a maximum of 59:59.

  8. Press and release the down arrow button and “TEMP” displays, along with preset temperature on the right side of the display. Press the product buttons to change the temperature. The temperature range is 190°F (88°C) to 380°F (193°C).

    Cook ID Change

  9. Press the down arrow button until “COOK ID” displays along with the product ID. For example, NUG would be the ID for nuggets. Use the product buttons to change the ID, following the same procedure as Step 6 above.

    Alarms (Duty 1 & 2)

  10. Press the down arrow button until “DUTY 1” shows in the left display, and an alarm time in the right display. Press the product buttons to set an alarm.

    Ex., If a Cook Cycle was set at 3 minutes, and an alarm was to go off after 30 seconds into the Cook Cycle, “0:30” would be set in the display at this time. When the timer counts down to 2:30 the alarm sounds.

    After the alarm time is set, press the down arrow button and “DUTY 2” displays, and a second alarm can be programmed.

    Quality Timer

  11. Press button until QUAL TMR is displayed along with preset holding time. Press product buttons to adjust holding time, up to 2 hours, 59 minutes.

    AIF Disable

  12. Press the down arrow button until “AIF DISABLE” displays along with “YES” or “NO”. Using the Left and Right arrow buttons change the display to “YES” if that product is to not be included in the automatic intermittent filtration operation, or “NO” if it is to be included.

    Assign Button

  13. Press the down arrow button until “ASSIGN BTN” displays, along with the product (ex: NUGGETS). If this product already has a product button assigned to it, that LED will be lit. To assign other product buttons to that product, press and hold the product button for 3 seconds and that LED stays lit. To remove a product from a button, press and hold the product button with a lit LED and the LED goes out.