Installing of Discs, Rods, and Spits

NOTICE -

When removing the rod assembly, make sure indicator is pointed up towards top of unit. If it is pointed down, the rod assembly will fall and may be damaged.

The gap between the end of the rod and the disc hub should not be more than 1/16" (1.6 mm) or damage to rod and disc assembly could occur.

Fit the spit with the “V” towards the rod. Reversing the spit will result in spits tilted at an angle.

  1. Fit discs up to appropriate disc support on each side of unit.

  2. Place each end of the rod assembly into the hubs on each disc.

  3. Slide the collars onto each hub of discs.

  4. Slide retention rings over hubs and into slot on rod.

  5. Slip angled spits onto discs, with the “V” of the angled spits towards the rod.