Stacking

A stacking kit must be used to stack rotisseries, or to stack a rotisserie on a display. This kit ensures 3 inches clearance from a rear wall. The part numbers of the stacking kits are 02664, for use on the SCR 6 and SCD 6, and 02665 is used on the SCR 8 and SCD 8.

Heavy Object

Take care when moving the fryer to prevent personal injury. The rotisserie weighs approximately:

SCR 6 380 lbs (172 kg)

SCR 8 500 lbs (230 kg)

  1. Lay unit on its side and bolt locking casters or legs, to the control side of unit.

  2. Using the bolts provided for the non-locking casters, or legs, bolt both the stacking spacer (provided in the kit) and the non-locking caster, or legs, to the front side of the unit. The stacking spacer should extend out the front of the unit about 3 inches.

  3. Carefully lift the rotisserie and place it on top of the display, or bottom rotisserie, with the controls on the same side.

  4. Remove the three side panel screws from the top unit and remove the three top side panel side screws from the bottom unit.

  5. Mount the stacking brackets to each side of the units as shown using the screws removed in step 4.

Unit is now ready for use.

For Price Costco units being installed in Canada, proceed with the following additional stacking steps:

  1. Remove the black plug button from the top of the upper unit.

  2. Remove the screws from the channel assembly and take the top two parts apart.

  3. Remove the screws along the corners of both top and bottom units.

  4. Mount one side of the channel to the units, using the screws previously removed in step 3.

  5. Route the power cord up through the mounted channel and attach the cover to the channel, using the screws previously removed in step 2.

Unit is now ready for use.