Assembling the Filter Pan

NOTICE -

During installation and reassembly be sure to apply oil to all O-rings to lubricate and to help prevent tears and oil loss. Every 90 days inspect O-rings and replace if damaged. Use a small screw driver to gently pry O-rings from their groove to inspect for damage. Reinstall by gently rolling into place.

NOTICE:

• Use a small screw driver to gently pry o-rings from their groove to inspect for damage. Reinstall by gently rolling them in to place.

• Watch a short video explaining how to lubricate the o-rings after installation.

Use these steps after disassembling and cleaning the filter pan, to install a new filter and reassemble the filtration system and pan assembly.

1. Slide a filter envelope on to the filter screen so the plug is protruding through the hole.

   

2. Fold-over the end of the filter envelope, and then slide a handle-clamp over the end. Ensure the handle faces the center plug.

3. Slide a handle clamp on to the other ends of the filter screen assembly. Ensure the handle faces the center plug.

   

4. Place the filter screen in the bottom of the filter pan with the plug side up.

   

5. Align the hole in the pickup tube with the filter screen plug, and then press down.

   

6. Position the pick-up tube so that both sides of the guides slide in to the holder bracket notches.

   

7. Press down on the pick-up tube to confirm it is fully engaged on the filter screen plug.

   

8. Place the crumb catcher into the drain pan so the legs straddle the filter screen.

   

9. Place the lid onto filter pan.

   

10. Push the filter pan into place and lock it into place using the locking latch.