FOR

Front Bulk Disposal

This section explains the bulk oil process for draining and disposing of oil. Once the oil has degraded, the vat is drained completely and refilled with new oil. The degraded oil is pumped in to a bulk oil storage container using menu commands from the fryer's control board.

NOTICE -

To protect community sewer lines, oil must be trapped and disposed of through bulk removal. Hot oil can coagulate when cooled, which clogs pipes and sewer lines. Always dispose of oil in to an approved bulk oil disposal storage container or approved grease trap. Never pour oil down a public sanitation drain.

Access the Dispose Menu

Use the following steps to access the disposal menu. An indicator light displays next to active options during procedure.

Press and hold the Main menu button until *MAIN* displays. The Main menu displays.
Press the 1. FILTER button. Additional menu items display.
Press the Main menu button twice. The dispose menu displays.

Front Disposal Reminder - Connect the Hose

NOTE: Rear dispose systems should always have the hose connected to the fryer, so no such reminder displays.

If set for front disposal (hose), the control displays a reminder to connect the hose between the fryer and the disposal cart (tank). Confirm that the hose is securely connected on both ends at the tank and at the fryer then press the YES button to proceed.

Drain the Oil

Drain the oil from the vat by doing the following:

Press the 7. DISPOSE button. The message DRAIN POT? and YES NO displays.
Press the YES button. DRAINING displays.
Wait. The oil from the vat drains in to the drain pan. When complete, the message =PURGE= Pump new oil push old oil from ports displays.

Purge the Fittings

Degraded oil remains inside the lines, valves and fittings. To completely purge the degraded oil, do the following:

Press the PUMP button. The pump runs for a few seconds, new oil pumps in to the vat, then the pump stops.
If necessary, press the PUMP button again to ensure the lines, valves and fittings are purged.

Wipe Out the Vat

To ensure degraded oil does not mix with new oil, do the following:

Put on Personal Protective Equipment (PPE).
Lift and secure the lid. Refer to Lifting and Securing the Lid for instructions.
Use a cloth or paper towel to wipe the remaining oil down the vat drain and clean the vat surface.
When done, press the next► button. A dispose, pump oil to waste tank message displays.

Front Disposal of the Oil - Only

NOTE: If set for Rear Disposal the bulk oil hose is connected to the rear of the fryer continue to Rear Disposal of the Oil - Only.

To pump the degraded oil from the drain pan to the bulk oil storage container, do the following:

Press the PUMP button.
Wait. The pump begins siphoning the oil out of the drain pan.
When the drain pan is emptied of oil, or the bulk oil storage container is full, release the PUMP button.

WARNING! Do not overfill the oil disposal shuttle. Hot oil overflowing onto the floor may cause severe burns and / or a fall risk.

NOTE: Depending on the size of the bulk oil disposal container, this procedure may need to be performed several times to fully drain the vat. Release the PUMP button at any time to stop pumping.
Continue at next step:
- If you fill the vat manually continue at, Fill the Vat Manually.
- If you fill the vat from bulk continue at, Fill the Vat from Bulk.

Fill the Vat Manually

Fill the vat with new oil by doing the following:

Press the next► button. EXIT DISPOSE? and YES NO displays.
Press the YES button. CLOSING... and then - OFF - displays.
Remove, clean and dry the drain pan and install a new filter. Refer to Drain Pan Assembly for instructions.
Insert the drain pan under the unit until it latches.
Manually fill the vat, by pouring oil from a container, to the lower limit line with new oil.
Power on the unit and return to normal operation.

Fill the Vat from Bulk